Setting Leaf Media - MIMAKI UJV55-320 Operation Manual

• With the narrow take-up
device, the media is routed as
shown in the figure to the
right.
No tension bar is used.
(2) In the same manner, fix the left side and right
side of the media.
• Pull roll media evenly for right and left, check
that there is no slack or waviness on the
media, and paste tape in numerical order.
• When you place the tape, consider the
rolling-up direction.
5
Roll up the media.
• By using the switch and the button on the narrow
take-up device, select a media taking-up direction
and then take up the media.
Direction selector switch
Front side The take-up device winds the media
Direction
(FORWARD) with the printed side facing in.
selector
Rear side The take-up device winds the media
switch
(REVERSE) with the printed side facing out.
Turns the winding motion on/off.
(When you press the button and
ON/OFF button operate the take-up device, the device
keeps taking up the media until you
press the button again.
*1. You can also change the setting so that the taking-up operation only
lasts while the ON/OFF button is being pressed. For details, refer to
"Setting Take-up unit" in machine settings.
6
Follow the steps 13 and later of "Setting
two narrow roll media (twin rolls)".
( P.2-15)
2-20
ON/OFF button
*1
)

Setting leaf media

Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Open the front cover and raise the clamp
lever.
Front cover
2
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
3
Hold the media with the media press
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
Clamp lever
Media Press