Setting A Auto Power-Off; Setting Feeding And Take-Up Unit - MIMAKI Tx300P-1800 Operation Manual

Chapter 3 Machine setting
Function name
Mail Delivery
( P.3-19)
Select Event
( P.3-20)
Mail Address
( P.3-20)
Message Subject
( P.3-20)
EVENT MAIL
Server Setup
( P.3-21)
Transmit Test
( P.3-22)
RESET( P.3-23)
*1. Settable when both of DHCP and AutoIP are [OFF]
*2. Settable only when Auth. is not OFF
*3. Settable only when Auth. is POP before SMTP

Setting a AUTO Power-off

When no operation has been performed for the set time,
the power supply is automatically turned "OFF".
Press
1
in LOCAL.
• MACHINE SETUP MENU will be displayed.
Press
2
OFF", and press the
Press
3
press the
• Set Value : none, 10 to 600 min
Press the
4
end the setting.
3-14
Set value
ON / OFF
Print Start
Event
Print End Event ON / OFF
Error Event
Warning Event
Other Event
Set the e-mail address to which
you send the event mail.
Set the characters to write in the
subject of the event mail.
SMTP Address
SMTP Port No.
SENDER ADDRESS
Authentication
*2
User Name
Pass Word *2
*3
POP3 Address
APOP *3
Send the test e-mail.
(MENU) (twice)
to select "AUTO POWER
key.
to select a set value, and
key.
key several times to
Default
Set whether you send/ do not send the e-mail
OFF
when the set event occurs.
Set whether you send/ do not send the e-mail at
ON / OFF OFF
the start of printing.
Set whether you send/ do not send the e-mail at
OFF
the end of printing.
Set whether you send/ do not send the e-mail
ON / OFF OFF
when a error occurs.
Set whether you send/ do not send the e-mail
ON / OFF OFF
when a warning occurs.
Set whether you send/ do not send the e-mail
ON / OFF OFF
when an event other than the above occurs.
Alphanumeric characters and symbols (within 96
characters)
Alphanumeric characters and symbols (within 8 characters)
Set the SMTP server.
Set the SMTP port number.
Set the e-mail address to be used as the sender mail
address.
POP before
SMTP
Set the SMTP server authentication method (SMTP
SMTP
authentication).
Authentication
OFF
Set the user name used for the authentication.
Set the password used for the authentication.
Set the POP server.
Set ON/ OFF of APOP.
All setting values are returned to the status
default.

Setting Feeding and Take-up unit

For the "Feeding and Take-up unit" settings, set the
following items:
• Use feeding unit and take-up unit/ Do not use feeding unit or
take-up unit.
• Use/Do not use tension bar.
• Operation when the ON/OFF switch for feeding/ take-up unit
is pressed.
In this machine, by selecting how to use the tension bar in
the feeding/take-up unit setting, you can print by any of
the following four methods.
Tension bar
Use feeding and
take-up tension bar
Use on the feeding
side only
Use on the take-up
side only
Do not use tension
bar
Meaning
How to set the media
Set the media refer to P.2-16.
In P.2-16 "Using the tension bar",
configure the settings by excluding all
the operations for the tension bar on
the unused side.
Set the media refer to P.2-21.