Maintenance - MIMAKI Tx300P-1800 Operation Manual

This chapter
describes the items required to use this machine more comfortably, which are the
methods for the daily care, the maintenance of the ink cartridges etc.
Maintenance ................................................. 4-2
When to care ............................................... 4-2
Precautions for Maintenance ...................... 4-3
About Cleaning Solution.............................. 4-3
Cleaning the Exterior Surfaces ................... 4-3
Cleaning the Media Sensor ......................... 4-3
Cleaning folding bar (take-up side) ............. 4-4
Cleaning the tension roller .......................... 4-4
Cleaning the Ink receiving spacer ............... 4-4
Cleaning the Platen ..................................... 4-4
Cleaning the Fabric Retainer /
Media press ................................................. 4-5
Cleaning of grit roller ................................... 4-6
About MAINTENANCE MENU ...................... 4-7
MAINTENANCE MENU at-a-glance ........... 4-8
Maintaining the Capping Station ................... 4-9
Cleaning the Wiper and Cap ....................... 4-9
Washing the Head Nozzle ......................... 4-10
Washing the Ink Discharge Passage ........ 4-12
When the Machine Is Not Used for
a Long Time .............................................. 4-13
Cleaning the Ink Head and the Area
around It ...................................................... 4-15
Nozzle Recovery Function .............................. 4-16

Maintenance

Reset the set value ....................................4-17
Check the condition for which nozzle
recovery cannot be performed ...................4-17
Enabling or disabling nozzle recovery
during a test print .......................................4-18
Automatic Maintenance Function ................4-18
Setting the Refreshing Intervals .................4-18
Setting the Tube Wash Intervals ................4-19
Setting the Cleaning Intervals and Type ....4-19
Suspend the nozzle cleaning .....................4-19
Fill up Ink .....................................................4-19
Replacing consumables ..............................4-20
Replacing the wiper ...................................4-20
If a Waste Ink Tank Confirmation
Message Appears ......................................4-21
Replace the waste ink tank with another ...4-21
Replacing the Cap Absorber ......................4-22
Replacing the Blow down fan filter .............4-22
Replacing the Pinch roller ..........................4-23
Replacing the Spout Rubber Assy .............4-24
Male Connector Absorbent for MBIS .........4-25
Chapter 4