Setting Top Blower; Setting The Display Of Media Residual - MIMAKI Tx300P-1800 Operation Manual

Press
(MENU)
1
in LOCAL.
• MACHINE SETUP MENU will be displayed.
Press to select "FEEDING/TAKE-
2
UP UNIT", and pressthe
Press the
3
• "FEEDING UNIT" will be selected.
Press to select a set value, and
4
press the
• Set Value : ON/ OFF
Press , and press the
5
• "FEEDING TENSION BAR" will be selected.
Press to select a set value, and
6
press the
• Set Value : ON/ OFF
Press , and pressthe
7
• "TAKE-UP UNIT" will be selected.
Press to select a set value, and
8
press the
• Set Value : ON/ OFF
Press , and press the
9
• "TAKE-UP TENSION BAR" will be selected.
Press to select a set value, and
10
press the
• Set Value : ON/ OFF
Press , and press the
11
• "Feeding/ Take-up SW" will be selected.
Press to select a set value, and
12
press the
• Set Value : Continuance/ Temporary
Continuance :
Switching ON / OFF the winding operation when
pressing the switch each time. (Take-up unit in
operation does not stop until press again ON /
OFF switch.)
Temporary :
Do the winding operation only while holding
down the switch. (When release the switch,
winding operation is stopped. )
• If you are using the direct-connection unit, the
winding operation will be carried out with the
"TEMPORARY" setting even if you select
"CONTINUANCE".
(twice)
key.
key.
key.
key.
key.
key.
key.
key.
key.
key.
key.
Chapter 3 Machine setting
Press the
13
end the setting.
• Set feeding/take-up tension bar in "FEEDING/
TAKE-UP" before setting media. Even if you try
after detecting the media width (
cannot set feeding/take-up tension bar.
• You can change the ON/OFF settings of Feeding/
Take-up unit after detecting the media width.
When turning OFF from ON
Feeding/take-up unit does not operate.
When turning ON from OFF
If torque limiter is attached, only take-up
operation without using tension bar is
performed.
If direct-connection unit is attached, take-up
operation is not performed.
• If you want to change the feeding/ take-up method
while setting media, remove the set media and
carry out the operations from step 1 again.

Setting Top Blower

Set the operation of the top blower in print.
Turn the top blower setting "ON", and you can set the
strength for the blower.
Press
(MENU)
1
in LOCAL.
• MACHINE SETUP MENU will be displayed.
Press to select "Top blower",
2
and press the
Press to select "ON", and press
3
the key.
ON : You can choose the air volume of the blower.
OFF : The top blower does not work while printing
process. Proceed to step 6.
Press to select "STRENGTH",
4
and press the
Press to select a set value
5
(AUTO/ STRONG/ WEAK), and press the
key.
• Set value : ON/ OFF
Press the
6
end the setting.

Setting the Display of Media Residual

Whether the screen displays the remaining amount of a
media is set.
the remaining amount of a media is
When the media
displayed in Remote.
remaining amount
(However, when a leaf media is used,
display is turned to
the length of the media to be printed is
"ON"
displayed.)
When the media
the remaining amount of a media is not
remaining amount
displayed in the Remote.
display is turned to
"OFF"
key several times to
P.2-27), you
(twice)
key.
key.
key several times to
3-15
1
2
3
4
5
6