Error Messages - MIMAKI Tx300P-1800 Operation Manual

Error messages

When an error message is displayed, eliminate the error according to the chart below.
When displaying again,, contact your dealer or an office of MIMAKI to call for service.
Message
ERROR 108
HD THERMIS[1234]
ERROR 108
HD CONNECT[1234]
ERROR 122
CHECK:SDRAM
ERROR 128
HDC FIFO OVER
ERROR 128
HDC FIFO UNDER
ERROR 129
BATTERY EXCHANGE
ERROR 12a
HDC SPEED
ERROR 130
HD DATA SEQ
ERROR 146
E-LOG SEQ
ERROR 151
Main PCB V1R2
ERROR 152
Main PCB V2R5
ERROR 153
Main PCB V3R3
ERROR 154
Main PCB V05
ERROR 157
Main PCB VTT
ERROR 16e
Main PCB V3R3B
ERROR 15f
HEAD DRIVE HOT
ERROR 171
NEW HEAD CONNECT
ERROR 18a
Main PCB V_CORE
ERROR 18c
Main PCB V12
Cause
Head temperature control is defective.
An abnormality occurred in the head
connection.
SDRAM is defective.
Head control circuit board is defective.
The battery life end of the internal clock
is detected.
An error was detected in the waveform
being printed.
Sequential number abnormality of the
event log occurred.
Error occurs in the power supply system
of the main board.
An error occurred in the main PCB .
An error occurred in the main PCB .
Chapter5 Troubleshooting
Solution
• Turn off the power on the machine and turn it
on after a while.
When displaying again, contact your local
distributor, our sales office, or service center.
• Contact your local distributor to call for ser-
vice.
• Turn off the power on the machine and turn it
on after a while.
When displaying again, contact your local
distributor, our sales office, or service center.
1
2
2
2
5
6
5-7