Function Diagrams And Parameters - Siemens SINAMICS S120 Commissioning Manual
With startdrive
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
4.11.4
Function diagrams and parameters
Function diagrams (see SINAMICS S120/S150 List Manual)
• 2701
• 2704
• 2707
• 2711
Overview of important parameters (see SINAMICS S120/S150 List Manual)
• r0108.14
• r0899.0...15
Standstill monitoring
• r0060
• r0063
• r0063[0...2]
• p1224[0...3]
• p1225
• p1226[0...n]
• p1227
• p1228
• p1276
Open and close the brake
• p0855[0...n]
• p0856[0...n]
• p0858[0...n]
• p1216
• p1217
• p1218[0...1]
• p1219[0...3 ]
• p1220
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
Brake control - Simple brake control (r0108.14 = 0)
Brake control - Extended brake control,
stationary state detection (r0108.14 = 1)
Brake control - Extended brake control, open/close brake
(r0108.14 = 1)
Brake control - Extended brake control,
signal outputs (r0108.14 = 1)
Drive objects, function module;
Extended brake control
CO/BO: Status word, sequence control
CO: Speed setpoint before the setpoint filter
CO: Actual speed value smoothed
(for servo)
CO: Actual speed value
(for vector)
BI: Close motor holding brake at standstill
CI: Standstill detection threshold value
Standstill monitoring speed threshold
Standstill detection monitoring time
Pulse suppression delay time
Motor holding brake standstill detection bypass
BI: Unconditionally open holding brake
BI: Speed controller enabled
BI: Unconditionally close holding brake
Motor holding brake opening time
Motor holding brake closing time
BI: Open motor holding brake
BI: Immediately close motor holding brake
CI: Open motor holding brake, signal source, threshold
Commissioning
4.11 Configuring brake control
305
Advertisement
Table of Contents
