Creating Or Calling A Trace - Siemens SINAMICS S120 Commissioning Manual
With startdrive
Hide thumbs
Also See for SINAMICS S120:
- Function manual (1094 pages) ,
- Diagnostic manual (947 pages) ,
- Manual (848 pages)
Table of Contents
Advertisement
Additional information
The most important functions and settings for the trace function are explained in the
following chapters. Further, you can obtain detailed information about the trace function in
the Startdrive online help.
You can find an overview of the most important user interface elements of the trace function
in Chapter "User interface - trace function (Page 45)".
5.3.2.2
Creating or calling a trace
Traces in the form of trace configurations can be created in the project navigation. Trace
configurations that have been saved can be called and modified.
The following instructions describe how you create a trace configuration under the system
folder
Requirement
A drive has been configured that supports the trace function.
Creating a new trace
Proceed as follows to create a trace:
1. Double-click the "Add new trace" entry.
A new empty trace configuration is created for the drive. You must then configure the
details (see Chapter "Configuring a trace (Page 340)").
Figure 5-4
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
"Traces" - and how you display a trace configuration that has been saved.
Calling a new trace
Diagnostics
5.3 Diagnostics via Startdrive
339
Advertisement
Table of Contents
