Siemens SINAMICS S120 Commissioning Manual page 166

Commissioning
4.7 Basic parameterization of the drive objects
Defining a password for a user
You can create a password for both users "SINAMICS" and "Administrator" as follows:
1. Click on "Specify password".
The "Specify password" dialog opens.
Figure 4-66
2. Enter the new password in the "New password" input field. Pay attention to upper and
lower case.
3. Repeat the password in the "Confirm password" field.
For security reasons, the password entries displayed in the input fields are encrypted.
4. Click "OK" to confirm the input in the password dialog.
If both password entries were identical, the input dialog box is closed. If both entries do
not match, the input dialog box remains open and an error message is displayed. At the
same time, the two entries in the input dialog are cleared. In this case, you must enter the
password again in the two input fields.
The password is queried once when the corresponding web page is subsequently called.
5. Then save the project to accept the settings.
166
Specifying the password
Commissioning with Startdrive
Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1