1-7-3 Inverter Monitor Display
1-7-4 Corrective Action for Motor Faults
The inverter display unit (3-digit LED) provided for the standard
models has the following display, disregarding the modes (drive
mode, program mode).
Display contents can be selected by the 1st digit of constant 21
monitor selection.
Power on
"0": Output frequency
"1": Output current
Output frequency display
or output current display
"0":
"1":
Fault reset
Protection/alarm display
Protection/alarm display
Table 6 shows the check points and corrective actions of motor
faults.
Section 1-7
No minus display even in re-
verse run.
Less than 100 Hz:
1 digit below decimal point
100 Hz or more:
No digit below decimal point
Less than 10 A:
Fault
1 digit below decimal point
occurrence
10 A or more:
No digit below decimal point