Replacing A Plasma Display-Part Number Cts-Disp-65-Gen4; Required Information, Tools, And Equipment - Cisco 3200 Use And Care Manual

Replacing a Plasma Display—Part Number CTS-DISP-65-GEN4=
Make sure all system power is turned off before beginning this disassembly.
Caution
Remove the top camera hood by removing the screws that secure it to the bracket.
Step 2
Step 3 Remove the lens hood by removing the two screws on the bottom of the hood.
At the back of the camera cluster, disconnect the six cables: one Ethernet and one signal cable from each
Step 4
of the three camera processors. As you remove each cable, attach a strip of temporary masking tape and
mark as "left," "right," or "center" for identification.
Tip
Remove the camera assembly by removing the screws from the top and side flanges of the camera
Step 5
assembly support bracket. Retain the screws and set the assembly aside.
Step 6 Attach the new camera assembly to the mounting bracket using the same M8 screws that were removed.
See
Reattach the Ethernet and signal cables according to your temporary markings.
Step 7
Do not attach the camera hoods at this time.
Power on the system by completing the steps in the
Step 8
Perform the camera adjustment procedure and, if required, refocus and realign the camera.
Step 9
See the
Re-attach the camera hood and lens hood.
Step 10
Replacing a Plasma Display—Part Number
CTS-DISP-65-GEN4=

Required Information, Tools, and Equipment

To replace a display, you need the following information, tools, and equipment:
•
•
Uncrating and unpacking:
•
•
•
•
•
Cisco TelePresence System 3200
12-6
To enable easier access to the loose cables, temporarily attach them to the upper back of the
display with masking tape.
Chapter 8, "Assembling the Remaining Cisco TelePresence Elements"
"Setting Up the Cameras" section on page 10-6
Release Notes for Cisco TelePresence System, Release 1.4, OL-12074-05
Cisco TelePresence System Release 1.4 Administrator's Guide, OL-13676-03
Claw hammer or small pry bar
Large Phillips screwdriver
* Tin snips
* Pallet jack or hand cart (for moving components)
* Safety gloves
Chapter 12
for more information.
"Powering On the System" section on page
for more information.
Field-Replaceable Unit Guide
12-4.
OL-14521-01