Performing First-Time Setup - Cisco TelePresence IX5000 First-Time Setup

Performing First-Time Setup

To set up your system for the first time, complete the following steps.
Log in to the IX5000 administration GUI using the following syntax:
Step 1
http://<ip-address>
Where
ip-address
Tip If you did not make a note of the IP address and it no longer appears on the display, tap the number that
displays on the top left corner of the Touch 10 controller, then tap System Info.
Click First-Time Setup from the menu on the left.
Step 2
Click Start Setup.
Step 3
OL-27038-01
This problem is unlikely because to interfere with camera setup, the source of the interference would
have to be both red and rectangular in shape.
is the IP address you noted when the system was booting (see
Cisco TelePresence IX5000 and IX5200 First-Time Setup
Performing First-Time Setup
Figure 2 for an example).
15