YASKAWA SGDV User Manual page 52

Step Display after Operation
Refer to steps 5 to 9 and change the set value of Pn50B from n.6543 to n.6043.
10
Note: If setting Pn50B.2 to 0, the allocation for /P-CL can be changed from CN1-26 to CN1-15.
To enable the change in the setting, restart the SERVOPACK.
11
∗
If the Key has not been pressed but the
tion mode, any changes that have been made to the parameter will be saved in the SERVOPACK.
<Input signal polarities>
Input signal polarities are as follows when sequence input circuit is connected to a sink circuit. If connected to
a source circuit, polarities are reversed. For details, refer to 3.4.2 Sequence Input Circuit.
Signal
ON Low (L) level
OFF High (H) level
(4) Checking Input Signals
Input signal status can be checked using the input signal monitor (Un005). As for the input signal monitor
(Un005), refer to 8.3 Monitoring Input Signals.
Key has been pressed to select another mode such as the utility func-
Level Voltage Level
0 V
24 V
Keys
Contact
Close
Open
3.3 I/O Signal Allocations
Operation
3-17
3