YASKAWA SGDV User Manual page 304

10 Appendix
10.2.2 Parameters
Parameter
Size
No.
2 Input Signal Selection 3
4th 3rd 2nd 1st
digit digit digit digit
n.
Pn50C
10-22
Setting
Name
Range
0000 to FFFF
/SPD-D Signal Mapping
(Refer to 5.6 Internal Set Speed Control.)
0 Active when CN1-15 input signal is ON (low level).
1 Active when CN1-16 input signal is ON (low level).
2
Active when CN1-17 input signal is ON (low level).
3 Active when CN1-18 input signal is ON (low level).
4 Active when CN1-25 input signal is ON (low level).
5 Active when CN1-26 input signal is ON (low level).
6 Active when CN1-12 input signal is ON (low level).
7
Reserved (Do not change.)
8 Not active (fixed).
9 Active when CN1-15 input signal is OFF (high level).
A Active when CN1-16 input signal is OFF (high level).
B Active when CN1-17 input signal is OFF (high level).
C
Active when CN1-18 input signal is OFF (high level).
D Active when CN1-25 input signal is OFF (high level).
E Active when CN1-26 input signal is OFF (high level).
F Active when CN1-12 input signal is OFF (high level).
/SPD-A Signal Mapping
(Refer to 5.6 Internal Set Speed Control.)
0 to F
Same as /SPD-D Signal Mapping.
/SPD-B Signal Mapping
(Refer to 5.6 Internal Set Speed Control.)
0 to F
Same as /SPD-D Signal Mapping.
/C-SEL Signal Mapping (Control method change when ON (L-level))
0 to F
Same as /SPD-D Signal Mapping.
Factory When
Units
Setting Enabled
−
8888 After restart
(cont'd)
Reference
Classification
Section
−
Setup
Reference
Section
5.6.1
Reference
Section
5.6.1
Reference
Section
5.6.1
Reference
Section
5.7.1