YASKAWA SGDV User Manual page 305

Parameter
Size
No.
2 Input Signal Selection 4
4th 3rd 2nd 1st
digit digit digit digit
n.
Pn50D
2 Output Signal Selection 1
4th 3rd 2nd 1st
digit digit digit digit
n.
Pn50E
Setting
Name
Range
0000 to FFFF
/ZCLAMP Signal Mapping (Zero clamp when ON (L-level))
0
Active when CN1-15 input signal is ON (L-level).
1
Active when CN1-16 input signal is ON (L-level).
2
Active when CN1-17 input signal is ON (L-level).
3
Active when CN1-18 input signal is ON (L-level).
4 Active when CN1-25 input signal is ON (L-level).
5 Active when CN1-26 input signal is ON (L-level).
6 Active when CN1-12 input signal is ON (L-level).
7 Always active (fixed).
8 Not active (fixed).
9 Active when CN1-15 input signal is OFF (H-level).
A Active when CN1-16 input signal is OFF (H-level).
B Active when CN1-17 input signal is OFF (H-level).
C Active when CN1-18 input signal is OFF (H-level).
D Active when CN1-25 input signal is OFF (H-level).
E Active when CN1-26 input signal is OFF (H-level).
F Active when CN1-12 input signal is OFF (H-level).
/INHIBIT Signal Mapping (Reference pulse inhibit when ON (L-level))
0 to F
Same as /ZCLAMP Signal Mapping.
/G-SEL1 Signal Mapping (Gain change when ON (L-level))
0 to F
Same as /ZCLAMP Signal Mapping.
Reserved (Do not change.)
0000 to 3333
Positioning Completion Signal Mapping (/COIN)
0 Disabled (the above signal is not used.)
1 Outputs the signal from CN1-7 output terminal.
2 Outputs the signal from CN1-9 output terminal.
3 Outputs the signal from CN1-11 output terminal.
Speed Coincidence Detection Signal Mapping (/V-CMP)
0 to 3
Same as /COIN Signal Mapping.
Servomotor Rotation Detection Signal Mapping (/TGON)
0 to 3
Same as /COIN Signal Mapping.
Servo Ready Signal Mapping (/S-RDY)
0 to 3
Same as /COIN Signal Mapping.
Factory When
Units
Setting Enabled
−
8888 After restart
−
3211 After restart
10.2 List of Parameters
(cont'd)
Reference
Classification
Section
−
Setup
Reference
Section
5.3.5
Reference
Section
5.4.8
Reference
Section
6.9.5
−
Setup
Reference
Section
5.4.6
Reference
Section
5.3.8
Reference
Section
5.10.3
Reference
Section
5.10.4
10-23
10