YASKAWA SGDV User Manual page 303

Parameter
Size
No.
2 Input Signal Selection 2
4th 3rd 2nd 1st
digit digit digit digit
n.
Pn50B
Setting
Name
Range
0000 to FFFF
N-OT Signal Mapping (Reverse run prohibited when OFF (H-level))
0 Reverse run allowed when CN1-15 input signal is ON (L-level).
1 Reverse run allowed when CN1-16 input signal is ON (L-level).
2 Reverse run allowed when CN1-17 input signal is ON (L-level).
3 Reverse run allowed when CN1-18 input signal is ON (L-level).
4 Reverse run allowed when CN1-25 input signal is ON (L-level).
5 Reverse run allowed when CN1-26 input signal is ON (L-level).
6 Reverse run allowed when CN1-12 input signal is ON (L-level).
7 Reverse run prohibited.
8 Reverse run allowed.
9 Reverse run allowed when CN1-15 input signal is OFF (H-level).
A Reverse run allowed when CN1-16 input signal is OFF (H-level).
B Reverse run allowed when CN1-17 input signal is OFF (H-level).
C Reverse run allowed when CN1-18 input signal is OFF (H-level).
D
Reverse run allowed when CN1-25 input signal is OFF (H-level).
E
Reverse run allowed when CN1-26 input signal is OFF (H-level).
F
Reverse run allowed when CN1-12 input signal is OFF (H-level).
/ALM-RST Signal Mapping
(Alarm reset when OFF (H-level) to ON (L-level))
0 Active on the falling edge of CN1-15 input signal.
1 Active on the falling edge of CN1-16 input signal.
2 Active on the falling edge of CN1-17 input signal.
3 Active on the falling edge of CN1-18 input signal.
4 Active on the falling edge of CN1-25 input signal.
5 Active on the falling edge of CN1-26 input signal.
6 Active on the falling edge of CN1-12 input signal.
7 Reserved (Do not change.)
8 Not active (fixed).
9 Active on the rising edge of CN1-15 input signal.
A Active on the rising edge of CN1-16 input signal.
B Active on the rising edge of CN1-17 input signal.
C Active on the rising edge of CN1-18 input signal.
D Active on the rising edge of CN1-25 input signal.
E Active on the rising edge of CN1-26 input signal.
F Active on the rising edge of CN1-12 input signal.
/P-CL Signal Mapping (Torque Limit when ON (L-level))
0 to F
Same as Servo ON Signal (/S-ON) Mapping.
/N-CL Signal Mapping (Torque Limit when ON (L-level))
0 to F
Same as Servo ON Signal (/S-ON) Mapping.
Factory When
Units
Setting Enabled
−
6543 After restart
10.2 List of Parameters
(cont'd)
Reference
Classification
Section
Setup –
Reference
Section
5.2.3
Reference
Section
5.10.1
Reference
Section
5.8.2
Reference
Section
5.8.2
10-21
10