YASKAWA SGDV User Manual page 34

2 Digital Operator
2.5.3 Setting Parameters
Step
9
∗ If the
tion mode, any changes that have been made to the parameter will be saved in the SERVOPACK.
(2) How to Select Functions Using Parameters
The following example shows how to change the setting of the motor direction selection (Pn000.0) in the
function selection basic switch 0 (Pn000) to 1 (reverse direction).
Step
1
2
3
4
5
6
7
∗
When the setting is modified, the parameters whose modified setting is validated only after setting validation, the
warning A.941 "Change of Parameters Requires the Setting Validation" is displayed. Restart the SERVOPACK to
clear the warning and validate the new setting.
2-6
Display after Operation
Key has not been pressed but the
Display after Operation
To enable the change in the setting, restart the SERVOPACK.
Keys
Press the Key to write the settings.
Key has been pressed to select another mode such as the utility func-
Keys
Press the
eters and monitor displays.
Press the
"Un."
Press the
Press the
side (to the position of the first digit of Pn000.0).
Press the
of Pn.000.0.
Press the
The new setting of Pn000 is written to the SERVO-
PACK. The cursor moves to the parameter number
side and the warning A.941 is displayed.
*
Operation
Operation
Key to select the main menu of param-
or Key to move the cursor to
or Key to change "Un" to "Pn."
Key to move the cursor to the setting
Key once to set "1" for the first digit
Key.
(cont'd)