YASKAWA SGDV User Manual page 23

Encoder Output Pulse
Input
Sequence Signals
Input which can
be allocated
I/O
Signals
I/O
Signals
Fixed Output Servo alarm (ALM)
Output
Sequence
Signals
Output
which can
be allocated
Digital Operator
Communi-
cations
Function
Personal Computer
Communications (USB)
LED Display
Analog Monitor
Dynamic Brake (DB)
Regenerative Processing
Overtravel Prevention (OT)
Protective Function
Utility Function
∗
Speed regulation by load regulation is defined as follows:
No-load motor speed
Speed regulation =
Phase A, B, C: line driver
Encoder output pulse: any setting ratio (Refer to 5.3.7.)
Number of
7 ch
Channels
• Servo ON (/S-ON)
• Proportional control (/P-CON)
• Forward run prohibited (P-OT), reverse run prohibited
(N-OT)
• Alarm reset (/ALM-RST)
• Forward external torque limit (/P-CL), reverse external
torque limit (/N-CL)
• Internal set speed selection (/SPD-D, /SPD-A, /SPD-B)
Functions
• Control selection (/C-SEL)
• SEN signal (/SEN)
• Zero clamping (/ZCLAMP)
• Reference pulse inhibit (/INHIBIT)
• Gain selection (/G-SEL)
• Reference pulse input multiplication switching
(/PSEL)
Signal allocations can be performed, and positive and
negative logic can be changed.
Number of
3 ch
Channels
• Positioning completion (/COIN)
• Speed coincidence detection (/V-CMP)
• Rotation detection (/TGON)
• Servo ready (/S-RDY)
• Torque limit detection (/CLT)
• Speed limit detection (/VLT)
Functions
• Brake (/BK)
• Warning (/WARN)
• Near (/NEAR)
• Reference pulse input multiplication switching output
(/PSELA)
Signal allocations can be performed, and positive and
negative logic can be changed.
Connect the Σ-V digital operator (model: JUSP-OP05A-1-E) through an
applicable analog monitor unit (model: JUSP-PC001-E) and a connection
cable (model: JZSP-CF1S05-A3-E), or a relay cable (model: JZSP-CF1S00-
A3-E).
Supports SigmaWin+.
Based on the USB 1.1 standard (12 Mbps).
ALM (red), RDY (green)
Number of points: 2
±
Output voltage: 10 VDC (linearity effective range
Output through the analog monitor unit (model: JUSP-PC001-E), the connec-
tion cable (model: JZSP-CF1S05-A3-E), and the analog monitor cable
(model: JZSP-CA01-E).
Not supported.
Not supported.
Deceleration to a stop or free run to a stop at P-OT or N-OT
Overcurrent, overvoltage, overload, and so on.
Gain adjustment, alarm history, JOG operation, origin search, and so on.
- Total load motor speed
Rated motor speed
1.3 SERVOPACK Ratings and Specifications
±
8 V)
Analog
×
100%
(cont'd)
1
1-5