Table of Contents
Advertisement
Accessing the device for the first time
Setting up the configuration environment
To set up the configuration environment, see
the Web
interface," respectively. To access the device for the first time, you can log in to the device
from the console port or Web interface. To access the device through Telnet, first configure Telnet
settings from the console port.
Powering on the device
Checking before power-on
WARNING!
Locate the emergency power-off switch in the room before power-on so you can quickly shut power
off when an electrical accident occurs.
Before powering on the device, verify the following information:
•
The power cord and grounding cable are correctly connected.
•
The correct power source is used.
•
The console cable is correctly connected, the terminal or PC used for configuration has started,
and the configuration parameters have been correctly set.
•
The interface modules (if any) are correctly installed.
Powering on the device
Switch on the power source of the device.
Checking after power-on
After powering on the device, verify that:
•
The LEDs on the front panel indicate that the device is operating correctly. For more information
about LEDs, see "Appendix B LEDs."
•
The fan blades are rotating and air is exhausted from the air outlet vents.
•
The configuration terminal displays the following:
System is starting...
Press Ctrl+D to access BASIC-BOOTWARE MENU...
Press Ctrl+T to start heavy memory test..
Booting Normal Extended BootWare
The Extended BootWare is self-decompressing....Done.
****************************************************************************
*
*
*
"Logging in from the console
H3C SecPath BootWare, Version 1.05
20
port" and
"Logging in from
*
*
*
Advertisement
Table of Contents
