Operation Manual – Getting Started
H3C S9500 Series Routing Switches
Chapter 2 Logging in to Switch
2.1 Setting Up Configuration Environment through the
Console Port
Step 1: As shown in the figure below, to set up the local configuration environment,
connect the serial port of a PC (or a terminal) to the Console port of the switch with the
Console cable.
Figure 2-1 Set up the local configuration environment through the Console port
Step 2: Run a terminal emulator (such as Terminal of Windows 3X or HyperTerminal of
Windows 9X) on the computer. Set the terminal communication parameters as follows:
Set "Bits per second" to "9600", "Data bits" to "8", "Parity" to "none", "Stop bits" to "1",
and "Flow control" to "none", and select the "VT100" as the terminal type..
Figure 2-2 Set up new connection
RS-232 Serial port
Console cable
Console port
2-1
Chapter 2 Logging in to Switch