In This Book - Keysight Technologies InfiniiVision MSO-X 4022A Programmer's Manual

In This Book

This book is your guide to programming the 4000 X-Series oscilloscopes:
Table 1 InfiniiVision 4000 X-Series Oscilloscope Models, Bandwidths, Sample Rates
Band wid th
Sample Rate (interleaved,
non-interleaved)
2-Channel + 16 Logic
Channels MSO
4-Channel + 16 Logic
Channels MSO
2-Channel DSO
4-Channel DSO
The first few chapters describe how to set up and get started:
•
•
•
•
The next chapters provide reference information on common commands, root level
commands, other subsystem commands, and error messages:
•
•
•
•
•
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
200 MHz 350 MHz
5 GSa/s, 5 GSa/s,
2.5 GSa/s 2.5 GSa/s
MSO-X 4022A MSO-X 4032A
MSO-X 4024A MSO-X 4034A
DSO-X 4022A DSO-X 4032A
DSO-X 4024A DSO-X 4034A
Chapter 1, "What's New," starting on page 37, describes programming
command changes in the latest version of oscilloscope software.
Chapter 2, "Setting Up," starting on page 61, describes the steps you must take
before you can program the oscilloscope.
Chapter 3, "Getting Started," starting on page 69, gives a general overview of
oscilloscope program structure and shows how to program the oscilloscope
using a few simple examples.
Chapter 4, "Commands Quick Reference," starting on page 83, is a brief listing
of the 4000 X-Series oscilloscope commands and syntax.
Chapter 5, "Common (*) Commands," starting on page 197, describes
commands defined by the IEEE 488.2 standard that are common to all
instruments.
Chapter 6, "Root (:) Commands," starting on page 223, describes commands
that reside at the root level of the command tree and control many of the basic
functions of the oscilloscope.
Chapter 7, ":ACQuire Commands," starting on page 263, describes commands
for setting the parameters used when acquiring and storing data.
Chapter 8, ":BUS<n> Commands," starting on page 279, describes commands
that control all oscilloscope functions associated with the digital channels bus
display.
Chapter 9, ":CALibrate Commands," starting on page 289, describes utility
commands for determining the state of the calibration factor protection button.
500 MHz 1 GHz
5 GSa/s, 5 GSa/s,
2.5 GSa/s 2.5 GSa/s
MSO-X 4052A
MSO-X 4054A MSO-X 4104A
DSO-X 4052A
DSO-X 4054A DSO-X 4104A
1.5 GHz
5 GSa/s,
2.5 GSa/s
MSO-X 4154A
DSO-X 4154A
3