Measure:ipower - Keysight Technologies InfiniiVision MSO-X 4022A Programmer's Manual

23
:MEASure Power Commands

:MEASure:IPOWer

Command Syntax
:MEASure:IPOWer
The :MEASure:IPOWer command installs an input power measurement on screen.
Before sending this command or query, you must specify the channels probing the
input voltage, input current, output voltage, and output current (using the
:POWer:SIGNals:SOURce:VOLTage<i> and :POWer:SIGNals:SOURce:CURRent<i>
commands) and you must perform the automated signals setup (using the
:POWer:SIGNals:AUTosetup EFFiciency command).
Query Syntax
:MEASure:IPOWer?
The :MEASure:IPOWer query returns the measured input power.
Return Format
<return_value><NL>
<return_value> ::= the input power value in NR3 format
See Also •
•
•
•
566
(see page 1428)
":POWer:SIGNals:SOURce:VOLTage<i>"
":POWer:SIGNals:SOURce:CURRent<i>"
":POWer:SIGNals:AUTosetup"
":POWer:EFFiciency:APPLy"
on page 699
on page 698
on page 681
on page 639
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide