Cls (Clear Status) - Keysight Technologies InfiniiVision MSO-X 4022A Programmer's Manual

*CLS (Clear Status)

Command Syntax
*CLS
The *CLS common command clears the status data structures, the device-defined
error queue, and the Request-for-OPC flag.
If the *CLS command immediately follows a program message terminator, the output queue
NOTE
and the MAV (message available) bit are cleared.
See Also •
•
•
•
•
•
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1428)
"Introduction to Common (*) Commands"
"*STB (Read Status Byte)"
"*ESE (Standard Event Status Enable)"
"*ESR (Standard Event Status Register)"
"*SRE (Service Request Enable)"
":SYSTem:ERRor" on page 1107
on page 200
on page 218
on page 202
on page 204
on page 216
Common (*) Commands
201
5