Opee (Operation Status Enable Register) - Keysight Technologies InfiniiVision MSO-X 4022A Programmer's Manual

:OPEE (Operation Status Enable Register)

Command Syntax
:OPEE <mask>
<mask> ::= 15-bit integer
The :OPEE command sets a mask in the Operation Status Enable register. Set any
of the following bits to "1" to enable bit 7 in the Status Byte Register and
potentially cause an SRQ (Service Request) interrupt to be generated.
From Hardware
Event Registers
OR
To OPER bit in
Status Byte
Table 85 Operation Status Enable Register (OPEE)
Bit
14
13
12
11
10
9
8-6
5
4
Keysight InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
(see page 1428)
From Overload From Mask Test
Event Registers Event Registers
IOF IOC HWE OVLR MTE
14 13 12 11
OVLR MTE
IOF IOC HWE
14 13 12 11 10
+
Register
Name Description
IOF IO Operation Failed
IOC IO Operation Complete
HWE Hardware Event
OVLR Overload
--- ---
MTE Mask Test Event
--- ---
Wait Wait Trig
Trig
--- ---
Arm
AER?
Reg
Wait
Run
Trig
9 5 3
Wait
Run
Trig
9 8 7 6 5 4 3
When Set (1 = High = True), Enables:
Event when the IO operation fails.
Event when the IO operation completes.
Event when hard ware event occurs.
Event when 50Ω input overload occurs.
(Not used.)
Event when mask test event occurs.
(Not used.)
Event when the trigger is armed.
(Not used.)
Root (:) Commands
Run bit set if oscilloscope not stopped
:OPEReration:CONDition?
Operation Status Condition Register
:OPERation[:EVENt]?
Operation Status Event Register
2 1 0
:OPEE
:OPEE?
Operation Status Enable
(Mask) Register
6
245