Figure 12-18 Inserting The Disk Drive Module In A D-Brick2 - Silicon Graphics SGI Altix 3700 Bx2 User Manual

12: Maintenance and Upgrade Procedures
156
6. Orient the new drive carrier module so that the hinge of the handle is on the right.
Then slide the drive carrier module into the chassis until it is stopped by the
camming lever on the right of the module (see Figure 12-18).
s g i
s g i
s g i
Figure 12-18 Inserting the Disk Drive Module in a D-brick2
7. Swing the drive handle shut and press it to seat the drive carrier module. The
camming lever on the right of the module will engage with a slot in the chassis.
Continue to push firmly until the handle fully engages with the module cap. You
should hear a click as the latch engages and holds the handle closed.
8. Repeat steps 2 through 7 for all drive modules to be installed.
s g i s g i s g i
s g i
s g i
s g i
s g i
D-brick2
storage module
007-4377-002