Adjusting The Position Of The Rackmounted Module; Figure B-9 Securing The Module To The Rack - Silicon Graphics Prism Visualization System User Manual

Adjusting the Position of the Rackmounted Module

!
007-4701-003
6. Secure the module to the rack by inserting a 10-32 x 1/2-inch Phillips screw in the top hole
of each chassis ear (see Figure B-9).
2
TM
Figure B-9 Securing the Module to the Rack
Once the module is installed in the rack, you can adjust the position of the module in the rack (up
and down, side-to-side). To adjust the position of the module, loosen the front mounting screws,
adjust the module to the desired position, then tighten the mounting screws.
Caution: Do not lift the module by its bezel; it is not designed to handle the weight of the module.
Instead, use the chassis ears to move the module (see Figure B-9).
Using Silicon Graphics Prism Modules with a Rack
1 0
9
8
7
6
5
4
3
2
1
10-32 x 1/2-inch screws
193