Quick Transfer Of Parameter Settings Between Multiple Frequency Converters; Readout And Programming Of Indexed Parameters; Initialize The Frequency Converter To Default Settings In Two Ways - Danfoss VLT Compressor Drive CDS 803 Design Manual

How to Program
6.4 Quick Transfer of Parameter Settings
between Multiple Frequency Converters
When the set-up of a frequency converter is completed, it
is recommended to store the data in the LCP or on a PC
via MCT 10 Set-up Software.
Data transfer from the frequency converter to the LCP:
1. Go to parameter 0-50 LCP Copy.
2. Press [OK].
3. Select [1] All to LCP.
4. Press [OK].
Connect the LCP to another frequency converter and copy
6 6
the parameter settings to this frequency converter as well.
Data transfer from the LCP to the frequency converter:
1. Go to parameter 0-50 LCP Copy.
2. Press [OK].
3. Select [2] All from LCP.
4. Press [OK].
6.5 Readout and Programming of Indexed
Parameters
Select the parameter, press [OK], and press [
through the indexed values. To change the parameter
value, select the indexed value and press [OK]. Change the
value by pressing [
setting. Press [Cancel] to abort. Press [Back] to leave the
parameter.
6.6 Initialize the Frequency Converter to
Default Settings in two Ways
There are 2 ways to initialize the frequency converter to
the default settings.
Recommended initialization
1. Select parameter 14-22 Operation Mode.
2. Press [OK].
3. Select [2] Initialisation and Press [OK].
4. Power off the frequency converter and wait until
the display turns off.
5. Reconnect the mains supply. The frequency
converter is now reset, except the following
parameters:
•
•
•
48
®
VLT
▲
]/[
▲ ▼
]/[ ]. Press [OK] to accept the new
Parameter 1-06 Clockwise Direction
Parameter 8-30 Protocol
Parameter 8-31 Address
Danfoss A/S © 12/2015 All rights reserved.
Compressor Drive CDS 803
2-finger initialization
The other way to initialize the frequency converter to
default settings is through 2-finger initialization, which is
described in the following steps.
▼
] to scroll
1. Power off the frequency converter.
2. Press [OK] and [Menu].
3. Power up the frequency converter while still
pressing the keys for 10 s.
4. The frequency converter is now reset, except the
following parameters:
Initialization of parameters is confirmed by alarm 80, Drive
initialised in the display after the power cycle.
•
Parameter 8-32 Baud Rate
•
Parameter 8-33 Parity / Stop Bits
•
Parameter 8-35 Minimum Response Delay
•
Parameter 8-36 Maximum Response Delay
•
Parameter 8-37 Maximum Inter-char delay
•
Parameter 8-70 BACnet Device Instance
•
Parameter 8-72 MS/TP Max Masters
•
Parameter 8-73 MS/TP Max Info Frames
•
Parameter 8-74 "I am" Service
•
Parameter 8-75 Intialisation Password
•
Parameter 15-00 Operating hours to
parameter 15-05 Over Volt's
•
Parameter 15-03 Power Up's
•
Parameter 15-04 Over Temp's
•
Parameter 15-05 Over Volt's
•
Parameter 15-30 Alarm Log: Error Code
•
15-4* Drive identification parameters
•
Parameter 15-00 Operating hours
•
Parameter 15-03 Power Up's
•
Parameter 15-04 Over Temp's
•
Parameter 15-05 Over Volt's
•
15-4* Drive identification parameters
MG18N202