Oil And Water Pump - Installation - Triumph Scrambler 1200 XC Service Manual

3. Refit the spacer washer and drive sprocket. Apply ThreeBond 1374 to the fixing
and tighten to 12 Nm.

Oil and Water Pump - Installation

Before fitting the pump to the crankcase ensure the pump internal surfaces have
been wetted with clean engine oil. The pump may fail to pick up oil from the sump
if the surfaces have not been wetted. This will cause the engine to run without
engine oil pressure and will lead to severe engine damage.
1. Install four new O-rings to the water pump outlet sleeve.
2. Install two new O-rings to the oil pump outlet sleeve.
Service Manual - Scrambler 1200 XC
ciuk
1. Oil pump end plate
2. Fixings
1
2
3
4
chhm_1
1. Oil pump
2. Spacer washer
3. Drive sprocket
4. Fixing
1
CAUTION
346 of 640