Triumph Scrambler 1200 XC Service Manual page 457

Fault Code
P0914
P0917
Pinpoint T ests
Test
1 Check cable and terminal
integrity:
- Engine ECM pin B23
- Sensor pins 1, 3, 4
2 Check cable for short circuit:
- Engine ECM pin B23 to ground
- Engine ECM pin B34 to ground
3 Check cable continuity:
- Engine ECM pin B23 to sensor
pin 1
- Engine ECM pin B18 to sensor
pin 4
- Engine ECM pin B34 to sensor
pin 3
4 Check cable for short circuit:
- Engine ECM pin B23 to ECM
pin B34
5 Reconnect harness, clear fault
Service Manual - Scrambler 1200 XC
Possible cause
Gear position sensor
short circuit to ground or
open circuit
Gear position sensor
short circuit to 5 Volt
sensor supply
Result
OK
Faulty
OK
Short
circuit
OK
Open
circuit
OK
Short
circuit
OK
Action
View and note 'freeze-frame' data
if available.
View and note 'sensor' data.
Ensure sensor connector is
secure.
Disconnect the engine ECM and
proceed to pinpoint test 1:
Action
Disconnect sensor and
proceed to test 2
Rectify fault, proceed to test 5
Proceed to test 3
Locate and rectify wiring fault,
proceed to test 5
Proceed to test 4
Locate and rectify wiring fault,
proceed to test 5
Renew gear position sensor
and contact pin and proceed
to test 5
Locate and rectify wiring fault,
proceed to test 5
Action complete - quit test
457 of 640