Switch Housing Electrical Connectors - Triumph Scrambler 1200 XC Service Manual

Note
To aid orientation, there are coloured dots on each connector. The coloured
dots identify the bottom face of the connector.
When inserting the connectors, carefully locate the connectors into their
sockets, then use a suitable flat ended pin punch to push the connectors fully
home. An audible click can be heard when the connectors are fully inserted.
Do not use sharp tools, such as a flat bladed screw driver, to insert the
connectors.
10. Connect the left hand switch housing electrical connectors.
11. Use a new cable tie to secure the wiring harness to the switch housing.
12. Locate the master cylinder to the handlebars and position the clamp with the UP
arrow pointing upwards. Do not tighten the clamp bolts at this stage.
13. Align the split line of the master cylinder clamp to the alignment mark on the top
surface of the handlebar. Tighten the clamp fixings, upper one first, to 8 Nm.
Service Manual - Scrambler 1200 XC
1
1.

Switch housing electrical connectors

2
4
1
3
635 of 640