Triumph Scrambler 1200 XC Service Manual page 187

14. Remove and discard the accessible camshaft sprocket fixing. Install a new
encapsulated fixing and tighten to 22 Nm.
15. Remove the T3880601 - Camshaft Timing Pin.
Always check that the T3880650 - Camshaft Timing Plate has been removed
before rotating the engine. Severe damage will result to the camshafts or
T3880650 - Camshaft Timing Plate if engine rotation is attempted with the tool
installed.
16. Rotate the engine until the remaining sprocket fixing is accessible.
17. Refit the T3880601 - Camshaft Timing Pin.
18. Remove and discard the remaining camshaft sprocket fixing. Install a new
encapsulated fixing and tighten to 22 Nm.
19. Remove T3880601 - Camshaft Timing Pin.
Note
With the aid of an assistant, hold the camshaft drive chain taut during removal
of the T3880651 - Timing Chain Tensioner.
20. Release the tension on the T3880651 - Timing Chain Tensioner.
21. Refit the timing chain tensioner, incorporating two new O-rings (see Camshaft
Drive Chain Tensioner - Installation).
22. To activate the tensioner, rotate the crankshaft anticlockwise two complete turns,
using the fixing fitted to the end of the crankshaft. Stop rotation when number 1
cylinder is at top dead centre (TDC).
Note
Before inserting the timing pin, ensure the slot on the camshaft is aligned with
the upper surface of the cylinder head.
23. Insert the T3880601 - Camshaft Timing Pin into the timing holes in the crankcase
and crankshaft.
Service Manual - Scrambler 1200 XC
3. T3880609 - Timing Torque Limiter
CAUTION
187 of 640