Triumph Scrambler 1200 XC Service Manual page 274

Failure to correctly adjust the balancer shafts may cause serous engine damage
and a poor rider experience.
3. Lubricate the balancer shaft, needle roller bearings and O-rings with clean
engine oil.
4. Fit the balancer shaft into the crankcase as noted during removal.
5. Support the balancer shaft and noting its orientation, slide the dead shaft through
the balancer shaft and into the upper crankcase.
6. Position the alignment mark on the dead shaft with the alignment mark on the
crankcase.
Note
The static alignment of the balancer shaft will allow for initial starting of the
engine.
Final adjustment must be carried out with the engine running and at operating
temperature, see Balancer Shafts Dynamic Adjustment.
Service Manual - Scrambler 1200 XC
2
3
cizd
1. Balancer
2. Dead shaft
3. Dead shaft clamp
CAUTION
1
2
274 of 640