Oil Pump End Clearance - Triumph Scrambler 1200 XC Service Manual

Oil Pump End Clearance

1. Remove the end plate from the pump.
2. Wipe the exposed areas of the rotors and the machined face of the end plate.
Note
The oil pump end clearance is measured using Plastigauge (Triumph part
number 3880150-T0301). Do not turn the oil pump during the clearance
measurement as this will damage the 'Plastigauge'.
3. Apply a thin smear of grease to the rotor and a small quantity of silicone release
agent to the face of the end plate.
4. Cut a length of the Plastigauge to fit across the rotor. Fit the strip to the rotor using
the grease to hold the Plastigauge in place.
5. Without any twisting action, refit the oil pump cover and tighten its fixings to 10
Nm.
6. Release the bolts and carefully remove the end plate.
7. Using the gauge provided with the Plastigauge kit, measure the width of the
compressed Plastigauge.
8. For specifications refer toLubrication.
Service Manual - Scrambler 1200 XC
Pump Body Clearance
2
cdqi_1
1. Outer rotor
2. Plastigauge
1
2
344 of 640