Triumph Scrambler 1200 XC Service Manual page 366

15. Fit the washer and a new lock nut to the cylinder head rear mounting bolt. Counter
hold the nut and tighten the bolt to 105 Nm.
16. Stage 3
17. Using T3880104 - Swinging Arm Adjuster Wrench, tighten the swinging arm pivot
bolt adjuster sleeve to 6 Nm.
18. Fit the washer and a new lock nut to the swinging arm spindle. Counter hold the
spindle and tighten the nut to 110 Nm.
19. Refit the swinging arm pivot cover to the left hand side of the frame.
20. On the left hand side, connect the engine ground cable.
21. Refit the rider's left hand control plate, fit the upper fixing only and do not fully
tighten at this stage.
Service Manual - Scrambler 1200 XC
4
5
5
4
1. Cylinder head front right hand mounting bolt
2. Cylinder head front left hand mounting bolt
3. Cylinder head rear mounting bolt
4. Washer
5. Lock nut
3
1
2
1
366 of 640