Do not use excessive amounts of sealer. The extra sealer may become dislodged
and could block the oil passages in the crankcases, causing severe engine
damage.
9.
Position the lower crankcase to the upper crankcase. An assistant may be
required to support the crankcase during alignment.
Note
The rear balancer shaft will rotate one tooth when the upper and lower
crankcase are joined.
10.
To check that the balancer shaft is correctly timed to the crankshaft proceed as
follows:
11.
Check that the dot mark on the rear balancer shaft gear is aligned with the tab on
the crankcase, as shown below.
Service Manual - Scrambler 1200 XC
Sealer Areas
1
cjcm
1.
Lower crankcase identification mark
2.
Rear balancer shaft dot mark
CAUTION
2
245 of 640