Clutch Cover - Removal - Triumph Scrambler 1200 XC Service Manual

Hide thumbs Also See for Scrambler 1200 XC:

Table of Contents

Fill the engine with the correct grade of engine oil (see Engine Oil and Filter

Raising the engine speed above idle, before the oil reaches all parts of the engine

can cause engine damage or seizure. Only raise engine speed after running the

engine for 30 seconds to allow the oil to circulate fully.

If the engine oil pressure is too low, the low oil pressure warning light will

illuminate. If this light stays on when the engine is running, stop the engine

immediately and investigate the cause. Running the engine with low oil pressure

will cause engine damage.

Start the engine and ensure that the low oil pressure warning light goes out

shortly after starting.

Stop the engine and check the engine oil level. Adjust if necessary (see Engine

Oil - Level Inspection).

Clutch Cover - Removal

Before starting work, ensure the motorcycle is stabilised and adequately

supported. This will help prevent it from falling and causing injury to the operator

or damage to the motorcycle.

Perform the following operations:

Seat - Removal

Battery - Removal

Disconnect the clutch cable at the clutch cover (see Clutch Cable - Removal).

Release the fixing and disconnect the gear change actuator arm at the clutch

Service Manual - Scrambler 1200 XC