Triumph Scrambler 1200 XC Service Manual page 585

2. While supporting the catalytic converter, remove the fixings and the finned clamps
securing the exhaust header pipe to the cylinder head. Remove the catalytic
converter.
3. If necessary, remove the oxygen sensor.
Before starting work, ensure the motorcycle is stabilised and adequately
supported. This will help prevent it from falling and causing injury to the operator
or damage to the motorcycle.
1. If removed, apply a thin smear of anti-seize compound to the threads of the
oxygen sensor, install the oxygen sensor and tighten to 25 Nm.
Note
To retain the gaskets during assembly, apply a smear of grease or petroleum
jelly to the gasket faces in the head.
2. Fit a new gasket to the cylinder head right hand port.
Service Manual - Scrambler 1200 XC
1. Left hand oxygen sensor connector
2. Right hand oxygen sensor connector
1
3
cjzu
1. Fixings
2. Finned clamps
3. Catalytic conveter
WARNING
2
1
585 of 640