Triumph Scrambler 1200 XC Service Manual page 528

original hose with a restrictor in it will not allow the carbon cannister to purge
correctly.
Failure to purge the carbon cannister correctly will cause irreparable damage to
the carbon cannister.
Note
If replacing the inlet manifold on models up to VIN 783906 check the purge
control valve hose for the restrictor, approximately 25 mm from the inlet
manifold end of the hose.
If the hose has the restrictor, replace the hose with a new hose without the
restrictor. Restriction is controlled by the spigot pressed into the new inlet
manifold.
When ordering replacement parts, always refer to the EPC.
1. Ensure the mating surfaces on the inlet manifold and the cylinder head are clean.
2. Fit three new seals to the mating surfaces of the inlet manifold.
3. Fit the inlet manifold to the cylinder head. Do not fully tighten the fixings at this
stage.
4. Ensure the mating surfaces of the throttle body and inlet manifold are clean.
5. Position the throttle body to the throttle body hose. Do not tighten the clamp at this
stage.
6. Fit the throttle body to the inlet manifold. Do not fully tighten the fixings at this
Service Manual - Scrambler 1200 XC
1
2
1. Inlet manifold
2. Seals
CAUTION
2
528 of 640