Do not use a power jet washer to clean the chain as this may cause damage to
the chain components.
Drive Chain Rubbing Strip - Check
Before starting work, ensure the motorcycle is stabilised and adequately
supported. This will help prevent it from falling and causing injury to the operator
or damage to the motorcycle.
Inspect the drive chain rubbing strip for cracks, damage or excessive wear. Replace if
necessary.
Side Stand - Clean/Lubricate
Removal
Before starting work, ensure the motorcycle is stabilised and adequately
supported. This will help prevent it from falling and causing injury to the operator
or damage to the motorcycle.
1.
Raise and support the motorcycle.
Wear hand, eye and face protection when unhooking the stand spring. Take great
care to minimise the risk of personal injury and loss of components.
2.
With the side stand in the up position, unhook the spring from the side stand and
remove it from the motorcycle.
3.
Remove and discard the E-clip securing the pivot pin.
4.
Remove the pivot pin and remove the side stand.
Service Manual - Scrambler 1200 XC
CAUTION
WARNING
WARNING
WARNING
3
123 of 640