Triumph Scrambler 1200 XC Service Manual page 584

If the engine has recently been running, the exhaust components may be hot to
the touch. Contact with the hot components may cause damage to exposed skin.
To avoid skin damage, always allow the hot parts to cool before working on the
exhaust system.
Note
Always note the position and orientation of exhaust clamps prior to releasing
them, and return them to the noted position and orientation on assembly.
Perform the following operations:
Seat - Removal
Battery - Removal
Exhaust Silencer - Removal
Left Hand Header Pipe - Removal
Fuel Tank - Removal
Note
Note the routing of the oxygen sensor harness for installation.
The oxygen sensor electrical connections must not be swapped between
cylinders. If the connections are swapped over, engine malfunctions will occur.
The right hand (Cylinder 2) oxygen sensor connector on the main harness has
a red connector (main harness side).
The oxygen sensors are NOT marked. Always ensure the right hand oxygen
sensor harness is connected to the main harness connector with the red
connector.
1. Disconnect the right hand oxygen sensor from the main harness.
Service Manual - Scrambler 1200 XC
L0824
WARNING
1
2
584 of 640