Clutch Cable - Check/Adjust; Rocker Shaft Tightening Sequence - Triumph Scrambler 1200 XC Service Manual

Note
Shims are available ranging from 2.00 mm to 3.20 mm in increments of 0.025
mm.
9. Fit the selected shim to the valve.
10. Refit the rocker arm and shaft, tighten the bolts in the sequence shown below to
10 Nm.
11. Repeat the procedure until all valves requiring adjustment have been correctly
set.
12. Rotate the engine several times to fully seat the shims.
13. Repeat the clearance checks on all valves, adjust as necessary.
Perform the following operations:
Camshaft Cover - Installation
Fuel Tank - Installation
Battery - Installation
Seat - Installation

Clutch Cable - Check/adjust

Before starting work, ensure the motorcycle is stabilised and adequately
supported. This will help prevent it from falling and causing injury to the operator
or damage to the motorcycle.
Service Manual - Scrambler 1200 XC
cia a

Rocker Shaft Tightening Sequence

1
WARNING
2
105 of 640