Triumph Scrambler 1200 XC Service Manual page 189

28. Remove the T3880650 - Camshaft Timing Plate.
29. Remove the T3880601 - Camshaft Timing Pin.
30. Lubricate the threads of the camshaft frame fixings with clean engine oil.
31. Fit the rocker shafts with the dot marks facing upwards and toward the camshaft
drive gear.
32. Fit the inlet and exhaust rocker shafts to cylinder number one as shown below.
Do not fully tighten at this stage.
33. Finger-tighten the fixings until the under head areas are in contact with the
camshaft frame.
34. Remove the fixing and rocker shaft from cylinder number two camshaft frame.
35. Lubricate the threads of the camshaft frame fixings with clean engine oil.
Note
The rocker shaft must be fitted with the dot marks facing upwards and toward
the camshaft drive gear.
36. Fit the inlet and exhaust rockers and shafts to cylinder number two. Do not fully
tighten at this stage.
Service Manual - Scrambler 1200 XC
4. Shims (cylinder1 inlet)
5. Shims (cylinder 2 exhaust)
6. Shims (cylinder 1 exhaust)
3
cja b
1. Fixings (inlet rocker shaft)
2. Fixings (exhaust rocker shaft)
3. Dot mark
1
2
189 of 640