Triumph Scrambler 1200 XC Service Manual page 455

Test
1 Check cable and terminal
integrity:
- Engine ECM pin B25
- Engine ECM pin A19
- Starter Relay pin 1
- Starter Relay pin 2
Fuse box fuse 3
2 Check cable for short circuit:
- Engine ECM pin B25 to ground
- Engine ECM pin A19 to ground
- Engine ECM pin B25 to engine
ECM pin A01
3 To access the black and grey
connectors on the right hand
switch housing, detach the front
brake master cylinder from the
handlebar (see ).
Check cable continuity:
- Engine ECM pin B25 to starter
relay pin 2
- Engine ECM pin A19 to starter
relay pin 1
- Fuse box fuse 3 to alarm pin 5
Alarm pin 3 to engine ECM pin
A19
Alarm pin 5 to right hand switch
housing black connector pin 3
4 Check cable for short circuit:
- Engine ECM pin B25 to ECM
pin A01
5 Reconnect harness, clear fault
code and run engine to verify
fault cleared
Service Manual - Scrambler 1200 XC
Result Action
OK Disconnect starter relay and
proceed to test 2
Faulty Rectify fault, proceed to test 5
OK Proceed to test 3
Short Locate and rectify wiring fault,
circuit proceed to test 5
OK Proceed to test 4
Open Locate and rectify wiring fault,
circuit proceed to test 5
OK Proceed to test 5
Short Locate and rectify wiring fault,
circuit proceed to test 5
OK Action complete - quit test
Fault still Contact Triumph service
455 of 640