4.3.5
Exception
You can configure the system alarm settings on this page.
Event Type: Displays the event types.
•
No Space on Disk: When an HDD is full.
•
Disk Error: When the HDD is not detected properly.
•
Video Loss: When a camera is not connected properly.
Switch: Check the box to enable the function.
Buzzer: Set up the time for buzzer to sound when an event is triggered. To disable the Buzzer
function, select Disable.
Alarm Out: Select an external alarm output device connected to the DVR, IPCam or both.
Alarm Output: Select an alarm output time (duration) when events occur. When an event is
triggered, the alarm will last based on the setup latch time.
Show Message: Check the box to display an alarm message on the upper-right corner of the
live channel when an event is triggered.
Send Email: Check the box to enable the Email alert function. When an event is triggered, the
DVR will send an email alert with a snapshot to the pre-configured Email receiver. Note that
for this function to work, you have to set up the Email function in advance (refer to 4.4.3
Email).
Default: Click to apply the default setting.
Apply: Click to save the settings.
74
H.265 VANGUARD II Series