Table of Contents
Advertisement
Installation
This section describes the installation procedures for the WindoWall Pro Series
Multi-Graphic Processor and the connectors on the rear panel. Topics include:
•
•
•
•
Installation Overview
The WindoWall Console software can control up to 16 MGPs in a videowall application. To
install and set up multiple WindoWall Processor units for a videowall, follow the steps below
(see the application diagram in
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Installation Overview
Rear Panel Features
Front Panel
Resetting
Disconnect power from the processors and turn off all other devices that will be
connected.
Install the four rubber feet on the bottom of the unit, or mount it using the supplied rack
mounting brackets (see
Mounting the WindoWall Pro
Attach all video sources to the input connectors of a matrix switcher, such as an Extron
CrossPoint.
If using HDMI inputs with the WindowWall Pro DI, connect each HDMI input source to
an HDMI distribution amplifier (DA), such as an Extron HDMI DA.
Connect the video outputs of the matrix switcher to the four sets of WindoWall Pro BNC
input connectors, or
If using HDMI inputs, attach each DA to one of the rear panel HDMI input connectors.
Connect the videowall displays to the RGBHV/YUV BNC output connector, the HDMI
output connector, or both.
Connect an active LAN Ethernet cable to the RJ-45 port on the WindoWall Pro rear
panel to establish a link to the network (see
If serial control is desired, connect an RS-232 cable from the host to the Remote
RS-232/422 connector on the rear panel for serial control (see
connector
on page
6).
Plug the WindoWall Pro, input devices, and output devices into grounded AC sources,
and power on all devices.
Install and set up the WindoWall Console software on your computer (see
the WindoWall Console Software
NOTE: Step 10 can be performed without the inputs, matrix switcher, or any other
hardware connected to the WindoWall Pro.
figure 1
on page 4 for a connection example).
d
LAN connector
on page 11).
WindoWall Pro Series • Installation
on page 68).
on page 7).
c
Remote RS-232/422
Setting Up
5
Advertisement
Table of Contents
