Grounding Cable Type; Cable Routing And Connection - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

ANSI Hardware Installation Manual
Observe the following safety notes.
14.3.1
As shown in Figure 136, the 7360 ISAM FX-8 includes two grounding cable
connectors. Each ground lug is a 4 AWG, with 1/4 in. holes, with 3/4 in. spacing,
single crimp, peep, copper, UL and CSA recognized dual-hole lug. The preferred
cable is 4 AWG, green with a yellow stripe. Other types and sizes of wire and lugs
can also be used provided they meet the requirements of Article 250 of the NEC.
14.3.2
The grounding cable must be used when the shelf is stand-alone and will not be used
if the shelf is assembled in a rack. The cable is routed through an opening in the right
side of the shelf to the grounding terminal.
The connections for the grounding cable are shown in Figure 136. The grounding
cable is connected to the shelf frame with hardware included with the shelf.
Issue: 09
Rack or frame must be suitably connected to the
Danger 1 —
office grounding network in accordance with Article 250 of the
national electrical code (NEC) to ensure UL and CSA
compliance. If outside the United States, ground per local
electrical codes and practices.
Possible risk of personal injury or damage to
Danger 2 —
equipment due to inaccurate or faulty ground cabling.
Inaccurate grounding connection can cause electric shock or
equipment damage when the rack power is switched on.

Grounding cable type

Cable routing and connection

3HH-12893-AAAA-TCZZA
DRAFT
7360 ISAM FX-8 shelf cabling
261