Fiber Cables - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

Fiber optic cable management in the
7360 ISAM FX-8 shelf
16.2.3
Standard single-mode fiber cables with LC connectors are connected to the SFP
optical modules for transmit (Tx) and receive (Rx) purposes.
The GPON and EPON SFPs require an SC/UPC connector.
The NELT-B requires 90° fiber connector strain relief boots.
16.2.4
Fiber management guides are recommended for installment on the 7360 ISAM FX
shelves to provide proper fiber optic cable handling. The kit contains:
•
•
One fiber management guide is required for every four LT cards.
16.3 Routing fiber optic cables
This section provides procedures for mounting fiber management guides, routing
and connecting fiber optic cables to the NT and LT cards for 7360 ISAM FX-8, and
for installing optical modules.
Figure
304
For an overview of the supported SFP modules, see
Note 1 —
the 7360 ISAM FX Product Information Guide.
Nokia recommends protecting any SFP cage that is
Note 2 —
not equipped with an SFP module, with a dust cover in order to
prevent dust intrusion.
The type of optical fibers selected must match the
Note 3 —
particular SFP to guarantee the overall optical budget in the
system and it's correct operation. Loss of optical power as a
result of a mismatch in materials must be avoided.

Fiber cables

Fiber management kit
fiber management guide for the NT and NTIO cards
fiber management guide for the LT cards
168 shows the 7360 ISAM FX-8 mounting of the fiber management kit.
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
DRAFT
Issue: 09