ANSI Hardware Installation Manual
Procedure 28
To install optical modules, proceed as follows:
1
2
3
Issue: 09
Installing an optical module
Caution — It is important to install optical modules prior to connecting
power to a 7360 ISAM FX shelf.
Put on an antistatic wrist strap and connect it to a grounding point.
Install an optical module as follows:
i
Align the optical module with an optical module port and slide it into the port until it clicks
into place.
ii
Remove the rubber cap from the optical module.
Note — The optical module can only be removed when the pull-down
bar is released.
STOP. This procedure is complete.
3HH-12893-AAAA-TCZZA
Fiber optic cable management in the
DRAFT
7360 ISAM FX-16 shelf
149