Ejector Handles For Lt Cards - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

ANSI Hardware Installation Manual
5
6
7
8
9
Procedure 43
Use the following procedure to remove a cards.
1
2
3
4
Figure 104
Issue: 09
Press the insertion/extraction tabs on the front panel to lock the card in place. Attach fixation
screws located at the top and the bottom of the front panel of the card; see Figure 103.
Maximum torque: 2.66 lbf-in. (0.3 N
The card first displays a heartbeat signal, that is, the green PWR LED is flashing. Then the
card displays an enabling operation signal:
•
the green PWR LED is steady on
•
the red ALM LED is off
In the same way, install all the planned LT cards for the shelf.
Install LT card dummy panels in any unused, unpopulated LT card slots to maintain proper
operation.
STOP. This procedure is complete.
To remove cards
Put on the antistatic wrist strap and connect it to the earth bonding point at the bottom of the
7360 ISAM FX-12; see Figure 99.
Test the ESD wrist strap with the ohmmeter to ensure effectiveness; it must measure 1 MΩ
+/-20% to ground.
Loosen the fixation screws located at the top and bottom of the front panel of the card.
Use the ejector handles to disengage the card connectors from the backplane. Figure
shows the ejector handles for LT cards. Figure

Ejector handles for LT cards

3HH-12893-AAAA-TCZZA
Installing cards in the 7360 ISAM FX-12 shelf
.
m).
105 shows the ejector handles for NT cards.
Withdrawl
DRAFT
Guiding plate
22376
104
207