Figure 220 Ejector Handles For Lt Cards; Figure 221 Ejector Handles For Nt Cards - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

Installing cards in the 7360 ISAM FX-4 shelf
Figure 220
Figure 221
5
6
Procedure 86
Use the following procedure to change the NGFC-G card on the 7360 ISAM FX-4.
1
2
380
Ejector handles for LT cards
Ejector handles for NT cards
Remove the card from its slot and place it in an ESD protective bag.
STOP. This procedure is complete.
To change the NGFC-G card
Before disconnecting the power cable, ensure power to the cables has been disconnected.
Warning — If the following steps to disconnect the power cables are
not followed exactly, there can be a possible fire hazard.
Remove the safety cover and power cable screws (loosen and remove the screws); see
Figure 222.
3HH-12893-AAAA-TCZZA
ANSI Hardware Installation Manual
Withdrawl
33.77 in.
85.8 cm
DRAFT
Guiding plate
25830
22375
Issue: 09