Recommended Tools - Nokia 7360 Intelligent Services Access Manager FX Series Hardware Installation Manual

ANSI Hardware Installation Manual

19.4 Recommended tools

The following tools are recommended:
•
•
•
19.5 Guideline for card installation
This section provides a general guideline for the correct installation of a card in a
shelf.
Procedure 81
To install a dummy front panel:
1
2
3
4
Issue: 09
screwdriver to secure cards
antistatic wrist strap for handling cards with ESD sensitive devices
ohmmeter to check connection of wrist strap to earth bounding point
Installing a dummy front panel
Gently plug the card in the 7360 ISAM FX shelf until the front panel of the card touches the
shelf. Guide the card to the right of the slot in the shelf card guides, while taking care that the
SMD components of the card do not touch the card mounted below.
For dummy front panels equipped with ejector handles:
•
Pull back the ejector handles.
•
Place left thumb at the left of the front panel, next to the mnemonic label, and place right
thumb on the front panel below the right ejector handle.
•
Push with the left thumb and guide with the right thumb. The ejector handles should move
inward.
•
Push both ejector handles simultaneously to completely insert the card in the shelf slot.
•
Lock the card in place by fastening the fixation screws.
For dummy panels not equipped with ejector handles:
•
Align the dummy front panel to the 7360 ISAM FX shelf LT slot, ensuring that the dummy
front panel thumbscrews are aligned to the shelf screw holes.
•
Hand tighten the thumbscrews. Fully secure thumbscrews using screwdriver.
If the installed dummy front panel supports pre-cabling:
•
Attach the cables to the faceplate by aligning the MDF or POTS cable head shell screws
with the faceplate standoffs, and secure the cable by tightening the connector screws
using a screwdriver.
3HH-12893-AAAA-TCZZA
Installing cards in the 7360 ISAM FX-4 shelf
DRAFT
369